Symantec NETBACKUP 7 Bedienungsanleitung PDF herunterladen (Seite 71)

After you remove the load balancing server, restart the NetBackup Enterprise

Media Manager service. The NetBackup disk polling service may try to use the

removed server to query for disk status. Because the server is no longer a load

balancing server, it cannot query the disk storage. Consequently, NetBackup may

mark the disk volume as DOWN. When the EMM service restarts, it chooses a

different deduplication server to monitor the disk storage.

If the host failed and is unavailable, you can use the tpconfig device configuration

utility in menu mode to delete the server. However, you must run the tpconfig

utility on a UNIX or Linux NetBackup server.

For procedures, see the NetBackup Administrator’s Guide for UNIX and Linux,

Volume II.

To remove a media server from a deduplication node

For every storage unit that specifies the media server in Use one of the

following media servers, clear the check box that specifies the media server.

This step is not required if the storage unit is configured to use any available

media server.

In the NetBackup Administration Console, expand Media and Device

Management > Credentials > Storage Server.

Select the deduplication storage server, then select Edit > Change.

71Managing deduplication

Managing deduplication servers

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 121 122

Keine Kommentare

Symantec NETBACKUP 7 Bedienungsanleitung Seite 71